SOLVED: 2001 chevy s10 wiring diagram rear tailights under - Cars & Trucks (2024)

SOURCE: plug wire diagram

This was all I could come with, hope it helps.

SOURCE: Engine Wire diagram for S10

go to autozone.com and you can register any type car and they have pretty good prints and service manuals on line. I have an 89 chevy s10 I just rebuilt my motor and overhauled the complete truck just waiting on a new paint job. best of luck

SOURCE: i need a 1987 chevy S10 vacuum hose routing diagram

Go to Autozone.com, become member, will give you repair manual,location of parts,diagrams.

SOURCE: need Rear Brake Diagram for 1994 Chevy K2500 4x4

Here is the diagram,It is always a good idea to only disaasemble one side so you can use the other side as a reference,I also reccomend using a set od brake pliers,they will the disassembly and reassembly much easier.

SOURCE: need diagram for brake lines 1998 s10 blazer

If you aren't experienced with brakes you should see a mechanic. With metering valves, proportioning valves, ABS accumulators and other variables they need a trained eye. A master cylinder could be leaking into the vacuum system and not visible. Sometimes a wet backing plate can identify a leaky wheel cylinder. Portions of the line are rubber hoses. Even parts that are not leaking may be damaged and causing problems elsewhere.

Upload

Upload an image from your computer

Loading...

prevnext

0helpful

1answer

1helpful

1answer

0helpful

1answer

0helpful

1answer

Is this a truck or SUV? If truck, probable cause is a cut harness between the cab and rear under the bed. For both, check the harness connector underneath at the back.

0helpful

1answer

have you tried some of the chevy 4x4 forums. they have diagrams and many work on these vechiles. i have received good info from them before

4helpful

2answers

Not a regular fuse for headlights. Usually a relay that trips if it overheats and resets when it cools off. Often under the hood. Probably means you have a short circuit somewhere. A hot wire touching ground , often at rear of vehicle, Are your tailights still on ? If headlights and taillights go off together then problem is definately a short.

0helpful

1answer

This is not a full answer, but a tip on an easier way.to get to the pump. Instead of removing the gas tank. Just pull the bed off the truck! I guarantee that it will be easier. I did this on a 2001 S10 and it took less that an hour to remove the bed.
Remove the spare tire, and the tube that the tool to lower the tire goes through. You will need to unplug your tail lights under the back or the bed on both sides. There is also a grounding screw for the tail lights on each side that needs to be removed. Remove the screws that hold the gas tank filler hose to the side of the bed - right by the filler cap. Remove the tailgate (to make the bed lighter). Follow the frame down the length of the bed and you will find the bolts holding the bed on. There should be 6 or 8 bolts. My S10 had 8 bolts and my son's full size Chevy PU had 6 bolts (go figure?). Then just lift the bed off the truck. We did my S10 with 3 people and it had a camper shell and rack on it. My son's full size truck was lifted off with only 2 people. I would suggest 4 people however - one on each corner to make it easier to lift and control.
Replace the pump as described above and then you can start the engine to make sure everything works before setting the bed back on. NOTE: The fuel pump grounds back with the tail light ground. If the engine doesn't start right away, try grounding the wire back by the tail lights. It works like a charm. This is an especially nice way to do it if the gas tank is full! I spent 18 years as a professional mechanic and this is one of the slickest, least known tricks I have come across. I wish I'd known about it when I was wrenching for a living! Cheers!

1helpful

1answer

38helpful

1answer

1998 Chevrolet S10 Pickup Stereo Radio Wiring Diagram.
Radio Constant 12V+ Wire: Orange
Radio Switched 12V+ Wire: Yellow
Radio Ground Wire: Black
Radio Illumination Wire: Gray
Radio Dimmer Wire: Brown
Radio Antenna Trigger Wire: N/A
Radio Amp Trigger Wire: N/A
Front Speakers Size: 4′ x 6′
Front Speakers Location: Dash
Left Front Speaker Wire (+): Tan
Left Front Speaker Wire (-): Gray
Right Front Speaker Wire (+): Light Green
Right Front Speaker Wire (-): Dark Green
Rear Speakers Size: 4′ x 10′
Rear Speakers Location: Side Panels
Left Rear Speaker Wire (+): Brown
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Dark Blue
Right Rear Speaker Wire (-): Light Blue

0helpful

1answer

Have you chk. the tailight plug under the bed in the rear? could have come unpluged, or corroded, do you have a trailer plug? chk. that. Has anyone cut into tailight wires for trailer lights? If you find no problem back there then its time to trace the wires from rear to front, broken wire someware.